Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

6506 EtherChannel

I have two Cat 6506 with 2 1000Basex Gbic blades each in slots 2 & 3. Can you form an Etherchannel group with ports on different blades i.e. ports 2/16 & 3/16?

Running CatOS 8.3(3).

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Blue

Re: 6506 EtherChannel

Hi John

Yes that is the right command for CatOS.

Jon

Re: 6506 EtherChannel

Hi

As Jon said the commands are correct.

Thanks

Mahmood

4 REPLIES

Re: 6506 EtherChannel

Hi

As long as the ports are of same type u can form the ether-channel with ports on different blades within the same chassis.

Thanks

Mahmood

Community Member

Re: 6506 EtherChannel

Mahmood

Thank for that. the config would be -

set port channel 2/16 3/16 on? (Both switches).

Regards John

Hall of Fame Super Blue

Re: 6506 EtherChannel

Hi John

Yes that is the right command for CatOS.

Jon

Re: 6506 EtherChannel

Hi

As Jon said the commands are correct.

Thanks

Mahmood

135
Views
0
Helpful
4
Replies
CreatePlease to create content