02-03-2007 12:00 AM - edited 03-05-2019 02:08 PM
Hi all,
i have tried converting my 6509's existing CatOS {version 8.4} to IOS {12.2}, following the manual process. the 6509 has a Sup2 & an MSFC2.
When i was done uploading the IOS & restarted the switch, the switch would boot normally, but the RP would crash & generate crash info file in the switch's flash. i am wondering if anyone has experienced such a case.
thank you,
-Mohamad.
02-03-2007 04:49 AM
I have done this succesfully in the past.
The procedure is described in:
Goodluck!
Regards,
Leo
02-21-2007 10:52 AM
I have the same situation with 6509 Sup2/MSFC2. It works fine with Hybrid, but when I'm trying to upgrade it to the native IOS the SP boots perfectly but RP crashes:
00:00:01: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.
00:00:01: %C6MSFC-3-NOCPUVER: Invalid CPU ID 9999. System crashed to ROMMON
00:00:02: %SYS-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.
00:00:02: %OIR-6-CONSOLE: Changing console ownership to switch processor
I've tried to update RP rommon, to change the IOS version - no luck. It's always the same problem (%C6MSFC-3-NOCPUVER).
Any ideas?
02-22-2007 01:52 AM
Hi,
i have escalated this issue to a Cisco partner. i should get an answer within a couple of days, and i'll keep you posted.
07-10-2007 07:17 PM
did you get any answer from cisco?
same problem here
07-12-2007 05:27 AM
Hi Soheil,
actually i did not; this case remains unsolved. let me know if you get to the bottom of it.
thanks,
-Mohamad.
11-25-2008 05:11 AM
Same issue faced while trying to upgrade the MSFC.
Any suggestions!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: