Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6509 copy sup-bootflash to ATA flash

Trying to copy the system image file from the sup-bootflash to a new 64MB ATA flash card. Yes the software can support the 64MB card.

The ATA flash card was formated successfully, however I cannot copy the system image to it so that it can boot after a power loss.

The command I tried was:

console(enabled) copy sup-bootflash: slot0:

The source filename was typed in as shown in the Show Verison command.

The result was: Error opening slot0: no such device.

I suspect that I am missing something obvious as I am new to Cisco Switches.

Thanks

Dave

Everyone's tags (3)
1 REPLY
Hall of Fame Super Blue

Re: 6509 copy sup-bootflash to ATA flash

Dave

Do a "dir /all". You may well find that it is not slot0: but disk0: or possibly slot1:

Jon

611
Views
0
Helpful
1
Replies
CreatePlease to create content