Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

6509 core switch

Hello,

I'm configuring a 6509 core switch that has 4 blades and each blade has 48 ports by default the ports are shutdown.  I know I can do a port range with a no shutdown command to brings all ports up for each blade. However is there only one command that can make all ports active on each blade or a module command that can bring all ports for each 48 port blade?

Thanks,

3 REPLIES
Hall of Fame Super Blue

6509 core switch

Horacio

From memory the int range command can be used to specify ports on different linecards so you could try one command that includes the range for all ports on all linecards. Cant say for sure it will work but i seem to remember doing something like this before.

Jon

New Member

6509 core switch

Do u remember the format of the command?

Hall of Fame Super Gold

6509 core switch

conf t

interface range G1/1 - 48 , G2/1 - 48 , G3/1  - 48

no shutdown

end

75
Views
0
Helpful
3
Replies
CreatePlease to create content