Currently we have two (2) 2500 watt power supplies in our 6509-E chassis. We wanna migrate to the 6000 watt power supplies - are there any known issues with using opposite wattage power supplies. For example:
Remove one 2500 W and replace with one 6000 W meaning we will have one 6000 and one 2500 watt power supply inserted at the sametime so that we don't have to bring the box down.
u can replace 2500W power supplies with 6000W when switch is up, it will not affect ur production but be sure that u replace 1 power supply at a time. Do not remove both the power supplies at same tym.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...