Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

6509-E w/ IOS - possible to change destination syslog port

We have a Splunk box set up for syslog message retrieval (among other duties). We want to use a custom port other than UDP/514. Is it possible on a 6509-E running IOS 12.2 to change the destination syslog port?

Thanks in advance!

Shane

2 REPLIES
New Member

Re: 6509-E w/ IOS - possible to change destination syslog port

If you want to change the ports and run different instances of syslog monitor than you try this command switch(config)#logging host X.X.X.X transport udp port ## . This will change the port that the syslog messages are sent on and you will just have to figure out how to filter the different ports on the monitoring end.

New Member

Re: 6509-E w/ IOS - possible to change destination syslog port

Unfortunately, this command structure isn't available in IOS Version 12.2(33)SXH2a on a 6509-E. After logging host x.x.x.x I only have vrf and xml commands available. Thanks though.

Shane

1051
Views
0
Helpful
2
Replies
CreatePlease to create content