Unfortunately we're running on 110V power, so we only get half, thus I am planning on removing the X6148 in slot 6 to get the power consumption back down so we can return to redundant mode. It would be preferred to turn off inline power, if that is what is causing the 315W in module 6 (and 325W in module 8).
Slot 6 is "reserving" 315W and this is why the system power total" calculations it is basing its numbers on power used in slot 6 where stanby sup720 would be installed (not currently installed), it is reserving power required for standby Sup.
If you move the WS-X6148-RJ45V card that is currently in slot 6 to another slot it will consume 100W on the new slot but slot 6 will still be reserving 315W in case a redundant sup720 is installed someday.
325W is the real power required by this new WS-X6748-GE-TX card.
I did the individual port power inline never, but it didn't change the power allocated to the card because the card is in slot 6, which will always get 315W because it is set that way in case you put in a secondary Sup720.
I'm solving it by moving the card from slot 8 up to the slot 6 position and removing the old slot 6 card entirely.
That will reduce the power just enough to go back into redundant power mode.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.