Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6509 Non E concern

I have 6509 non E chassis. Do I have any need for concern if I want to deploy VoIP? Can I deploy the CCM modules andthe IOS to support them in a non E chassis?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: 6509 Non E concern

Hi

You can still run the sup720 with the latest IOS on the 6500 non-E chassis and this confgiuration AFAIK will take all the service module cards including yours - i'm assuming you are referring to the CMM module ?

If however you want to power IP phones from the 6500 then yes it may be a concern. Attached is a link to a 6500 Enhanced chassis doc

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletin0900aecd8017a5e7.html

scroll down to table 2 which covers number of phones that can be powered on different chassis.

HTH

Jon

2 REPLIES
Hall of Fame Super Blue

Re: 6509 Non E concern

Hi

You can still run the sup720 with the latest IOS on the 6500 non-E chassis and this confgiuration AFAIK will take all the service module cards including yours - i'm assuming you are referring to the CMM module ?

If however you want to power IP phones from the 6500 then yes it may be a concern. Attached is a link to a 6500 Enhanced chassis doc

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletin0900aecd8017a5e7.html

scroll down to table 2 which covers number of phones that can be powered on different chassis.

HTH

Jon

New Member

Re: 6509 Non E concern

Thanks Jon,

You answered my question, and cleared my concerns. And yes, i was refering to the CMM mods.

219
Views
0
Helpful
2
Replies