Pls check the flash got currupted or not.. you can try one option, reboot the system and get in to rommon, and try the command, tftpdnld -r, after providing the IP ADDRESS , MASK, GATEWAY, FILE, parameters.(please check on cisco, for this command details) This will copy the image from the tftp, and will not try to save on Flash. If this is working, you can confirm that there is an issue with your flash.
The tftpdnld command does not work...it says "command not found". I specified all the other parameters already. I googled but didnt find anything for this. You might be right that the flash has a problem but I tried to xmodem but that didnt work either..Is there any other way to do this?
I used that same document to set the IP on it. But my switch does not like the tftpdnld command for some reason.. Yes it is an external flash card. I've tried reseating it many times. It decompresses the images..checks all systems but then gets stuck at the same place everytime
just format the flash in rommon mode and then use xmodem(choose send file option) and ensure that no firewall is open in ur desktop.it is stucking because of flash problem once u format it,it should go smoothly.
I formatted the flash drive and reloaded all the images onto it via another device. I thought perhaps the switch is having memory issues. I used another image with lower memory requirements but it didnt help. Its still stuck at the same spot ("autoboot image: ") I've tried xmodem but that doesnt go anywhere. I'm slowly running out of options here..
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...