Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

6509 show flash

Hello All,

Bit confused with output of show flash and show boot where is actual image used why it says slot0 in Boot and show version has image

'bootflash:BTSYNC_cat6000-supk8.7-6-10.bin

----------------

(enable) sh flash

-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name

  1 .. ffffffff bdfea4c9  a32d14   31 10431636 Jun 06 2005 13:48:47 BTSYNC_cat6000-supk8.7-6-10.bin

5559020 bytes available (10431764 bytes used)

EBRSW012> (enable)

----------------

(enable) sh boot

BOOT variable = bootflash:BTSYNC_cat6000-supk8.7-6-10.bin,1;slot0:ebrsw010\cat6000-supk8.7-6-10.bin,1;

9 REPLIES
New Member

6509 show flash

Hi Amit,

Try the following:

clear boot system flash slot0:ebrsw010\cat6000-supk8.7-6-10.bin

Regards

Richard

New Member

6509 show flash

Thansk Richard for reply please advise if this is service impacting command or only does refresh , also is there reboot required after this command ?

Regards

Amit

New Member

6509 show flash

Hi Amit,

This command is not service impacting.

I just clear out the second (wrong) boot variable. After the command show boot should just show the correct bootflash: entry. A reboot isn't needed for that, but maybe you have to save the config to see the change under show boot.

Regards

Richard

New Member

6509 show flash

Thanks Richard , It seems to   be working One query so "bootflash" is just name of a name remane of name of image or or is it a directory

(enable) sh flash

-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name

  1 .. ffffffff bdfea4c9  a32d14    9 10431636 Jun 14 2005 12:42:44 bootflash

5559020 bytes available (10431764 bytes used)

> (enable) sh boot

BOOT variable = bootflash:bootflash,1;

CONFIG_FILE variable = bootflash:switch.cfg

Configuration register is 0x2

ignore-config: disabled

auto-config: non-recurring, overwrite, sync disabled

ROMMON console baud: 9600

boot: image specified by the boot system commands

New Member

6509 show flash

could you post the output of:

dir bootflash:

I think this should also work under catos.


Regards

Richard

New Member

6509 show flash

Please find output below

> (enable) dir bootflash:

-#- -length- -----date/time------ name

  1 10431636 Jun 14 2005 12:42:44 bootflash

5559020 bytes available (10431764 bytes used)

New Member

6509 show flash

Is this a different device?
what is the output of

dir bootflash:bootflash/

New Member

Re: 6509 show flash

hello Richard ,

Yes its different switch , please find output below

(enable) dir bootflash:bootflash/

No such file

If any one can reply please       

New Member

6509 show flash

Hello ,

If anyone can help please

Regards

amit

325
Views
0
Helpful
9
Replies
CreatePlease to create content