Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6509 Sup HOT in rommon

hi, i have a Cisco 6509 and after to introduce the command "hw-module module 6 reset" in order to perform a reset, this module turn to rommon mode.

after that if I introduce de comand "boot" the module turn in HOT STANBY mode.

I attach some captures.

Regards.

1 REPLY
Cisco Employee

Re: 6509 Sup HOT in rommon

Is the configuration register set correctly on the standby's SP?  Please do the following and attach the output -

1) attach 6

2) show version

Your output also suggests that the standby console is disabled so you may need to enable it from the active SUP before trying to run 'show version' from the standby card -

Router(config)#redundancy

Router(config..)#main-cpu

Router(config..)#standby console enable

227
Views
5
Helpful
1
Replies
CreatePlease to create content