I configured 6509 VSS one of my customer,while chaecking failover. First i shut down the active switch traffic is going through secondary switch.Afterwards i restared active switch but that time secondary switch is also the reinsalaies all the port. Its takes 50 sec to come back so they consider that time down time.what might be the problem.
Here i need to clarfiy one thing primary is not rebooting.For failover testing i am shuting down the primary switch and checking the connectivity through ping form the server to router its happening fine.While powering up the primary switch again the secondary switch is rebooting.Now waht i have to do same as you said can i delete preempt and priority.Kindly let me know this.
In a scenario where you do not have priority and preemption, if you reboot both switches at the same time, switch-1 will always be the primary and switch-2 is the back up which you don't have access to make any config changes.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...