Hi, we a have two Catalyst 6509 in VSS mode. They have MECs configured to interconnect them with the distribution-layer switches (Catalyst 3560).
When a link member of the MEC downs some VLANs fails too, I mean, the final users attached to the 3560s in some VLANs loses connectivity. One of this VLANs are routed through SVI in the 6500, but not all of them, like the voice VLAN.
I can see the VLANs in the 3560 without any problem, and both logs (6500 and 3560) says anything about that. None VLAN are pruned on the trunks.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...