Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

6509 w/ SUP2: getting "unsupported feature" error with redundancy commands

I have a 6509 w/ dual/redundant SUP2 cards.

When running these commands on the main console:

redundancy

main-cpu

auto-sync startup-config

auto-sync running-config

auto-sync config-register

auto-sync bootvar

auto-sync standard

All of the “auto-sync” commands fail stating: “This command is an unreleased and unsupported feature”

When doing a “show ?” under main-cpu all it shows is “default” “exit” and “no”, so I'm not seeing any options for these commands. Are there any new commands that replace the “auto-sync” commands? I've been scouring Cisco and Google sites all morning with no luck.

Thanks, Mike

2 REPLIES

Re: 6509 w/ SUP2: getting "unsupported feature" error with redun

Hi

auto-sync is definitely the command you need. What is the IOS you are running ?

Community Member

Re: 6509 w/ SUP2: getting "unsupported feature" error with redun

I'm running 12.2.18SXF15a

Funny this is, the commands show up in the running config (and startup after doing a wr mem). And, when I make changes and save them it shows me a meesage that it's sync'ed to the standby SUP2.

It is the latest IOS, but I haven't found anything about this as far as open issues with it. And the version does support RPR+ too.

463
Views
0
Helpful
2
Replies
CreatePlease to create content