Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

6509 with SUP2 problem

I have a client that purchased a SUP2 w/ MSFC2 and a 6509 chassis. He is complaining of very long load times for the show run and write memory commands. This begins several hours after reload. I told him to eliminate the flash and RAM as the culprit by process of elimination. I was wondering if anyone had seen symptoms like this before. He is running IOS (tm) c6sup2_rp Software (c6sup2_rp-PK9SV-M), Version 12.2(18)SXD6. Thank You.

Will

2 REPLIES
Cisco Employee

Re: 6509 with SUP2 problem

Hi Will,

It is really depend on how big is the config and how busy is the CPU. If you have a really large config, "show run" will take some time. Same thing apply to a really busy switch.

You can verify it with "show proc cpu" and "show run | i bytes".

HTH,

jerry

Community Member

Re: 6509 with SUP2 problem

Thank you Jerry.

142
Views
0
Helpful
2
Replies
CreatePlease to create content