Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6509 WS-X6724-SFP PWRDOWN

Running Native Mode (IOS) on 6509 with following modules installed, but 6724 will not Power UP. Three different linecards in 2 different chassis show same symptoms. I don't believe we have 3 bad line cards. Running current IOS and researched line cards can be installed in any slot. Also verified we have proper Power Supply requirements met (2 x WS-CAC-4000W-US)

Any insight as to what I may be missing?

sh mod

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 8 CEF720 8 port 10GE with DFC WS-X6708-10GE SAL1103E94D

5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAD072403H5

6 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAD112700F6

8 48 CEF720 48 port 1000mb SFP WS-X6748-SFP SAL10499U6V

9 48 CEF720 48 port 1000mb SFP WS-X6748-SFP SAL1026SNZ0

Mod MAC addresses Hw Fw Sw Status

--- ---------------------------------- ------ ------------ ------------ -------

1 0018.b966.f2b0 to 0018.b966.f2b7 1.3 12.2(18r)S1 12.2(33)SXH4 Ok

5 000c.ce63.f690 to 000c.ce63.f693 2.1 7.7(1) 12.2(33)SXH4 Ok

6 001b.d59b.d630 to 001b.d59b.d647 2.6 12.2(14r)S5 12.2(33)SXH4 PwrDown

8 0019.aaf1.bf20 to 0019.aaf1.bf4f 1.8 12.2(14r)S5 12.2(33)SXH4 Ok

9 001d.4541.7b38 to 001d.4541.7b67 1.10 12.2(14r)S5 12.2(33)SXH4 Ok

Mod Sub-Module Model Serial Hw Status

---- --------------------------- ------------------ ----------- ------- -------

1 Distributed Forwarding Card WS-F6700-DFC3C SAL1127TEKF 1.0 Ok

5 Policy Feature Card 3 WS-F6K-PFC3A SAD072301MW 1.1 Ok

5 MSFC3 Daughterboard WS-SUP720 SAD072504YA 1.2 Ok

8 Centralized Forwarding Card WS-F6700-CFC SAL10360Q8Q 3.0 Ok

9 Centralized Forwarding Card WS-F6700-CFC SAL1211J8LL 4.0 Ok

Mod Online Diag Status

---- -------------------

1 Pass

5 Pass

6 Not Applicable

8 Pass

9 Pass

1 REPLY
Hall of Fame Super Silver

Re: 6509 WS-X6724-SFP PWRDOWN

Hello Keith,

I think the linecard is missing a DFC or CFC on it.

You may need to request them

in the sub-module output you see there no entry for slot 6

Few mounths ago we had the same problem: without a DFC or CFC the linecard should revert to bus mode but this is not accepted by the supervisor.

Hope to help

Giuseppe

772
Views
0
Helpful
1
Replies