Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Purple

6548 GE gig etherchannel restrictions

When we try to create a LACP etherchannel it won't take more than 2 in a etherchannel , I believe its due to a restriction of the 6548 card them selves , it comes back with an error and if you create port channel 1 , it will take any ports above 2 and stick them in portchannel 1A which the switch creates automatically ,anyone else ever see this with these cards . I believe I read a doc about this restriction that you cannot have more than 1 gig in a etherchannel on these cards. , anyone else run into this and can verify this is a problem with these cards ? supervisor is a 720 with 12.2.18 SXF9 code .

1 REPLY
New Member

Re: 6548 GE gig etherchannel restrictions

hi,it is an oversubscription scenario that we need to remember for these cards.I hope the following link helps.

http://cisco.com/en/US/products/hw/switches/ps708/products_system_message_guide_chapter09186a0080163dbf.html#wp1440564

139
Views
0
Helpful
1
Replies
CreatePlease to create content