Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6608 error

6608 often gets the following error if the port is not configured.

SYS-4-MODHPRESET:Host process (860)

As soon as the port is configured, no more error. How to fix this? Thanks

2 REPLIES
Silver

Re: 6608 error

That's normal. Your best bet is to configure all of the ports in CM, even if you don't plan to use them.

More info is at the following link:

http://www.cisco.com/warp/public/788/signalling/pri_troubleshooting.html

-Eric

Please remember to rate all helpful posts.

Cisco Employee

Re: 6608 error

Take a look at this link : http://www.cisco.com/en/US/customer/products/hw/switches/ps700/products_tech_note09186a008014f550.shtml#subtopic1m

...The workaround is to disable unused ports. Issue the set port disable mod/port command...

Regards,

Jocelyn Neto

173
Views
0
Helpful
2
Replies
CreatePlease login to create content