Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

7200 Etherchannel bug?

Our 7200 is currently etherchanneled to a 3750 stack(and working fine).

It *will* allow you to configure a port into any channel 1-64:

router(config)#int gig0/0

router(config-if)#channel-group ?

<1-64> Channel group number

But while in normal enable mode, will only let you check status of group 1-6:

router#sh etherchannel ?

<1-6> Channel group number

brief Brief information

detail Detail information

load-balance Load-balance/frame-distribution scheme among ports in port-channel

port Port information

port-channel Port-channel information

summary One-line summary per channel-group

router#sh etherchannel 10

^

% Invalid input detected at '^' marker.

Has anyone seen this before?

It is currently working just fine using channel ID 10, but annoying because I cannot use the normal show command I am used to using.

2 REPLIES

Re: 7200 Etherchannel bug?

Hi,

It appears to be a bug. I tried to issue the same command on one of my switches and (1-64) appeared as an option.

Upgrade the IOS dude :)

Cheers

Community Member

Re: 7200 Etherchannel bug?

Its running 12.4(21) already :-0

211
Views
0
Helpful
2
Replies
CreatePlease to create content