Hello,
I have been experiencing a random router crash on a 7206 router. Link states do not go down, but traffic stops passing and router can not be accessed on any of its Ip interfaces. I have two ways into this router running OSPF. Once the router is rebooted connectivity is restored for about 10-12 hours, then goes dead again. I am getting this PA bandwidth points error when running a show ver. I checked the configuration guide and I am not over the max FE100 interfaces for this router. I also have the interface spreadout across both internal buses. I got an fe100 in port 5, the other in port 6 and the third is on the I/O controller on board. I have attached the sh ver below.
I have other routers with the same exact config and do not receive this error. I am not convinced that this is the reason the router crashed, but need some info.
sh ver
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-IS-M), Version 12.3(9), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Fri 14-May-04 11:15 by dchih
Image text-base: 0x60008AF4, data-base: 0x61C74000
ROM: System Bootstrap, Version 11.1(13)CA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(22)S, EARLY DEPLOYMENT RELEASE SOFTWARE (fc2)
Markle_7206 uptime is 4 minutes
System returned to ROM by power-on
System image file is "slot0:c7200-is-mz.123-9.bin"
cisco 7206 (NPE200) processor (revision B) with 114688K/16384K bytes of memory.
Processor board ID 21303596
R5000 CPU at 200MHz, Implementation 35, Rev 2.1, 512KB L2 Cache
6 slot midplane, Version 1.3
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
Number of Fast PAs = 3
Number of Fast+Medium PAs = 3
Total number of PA bandwidth points consumed = 600
Please refer to the following document "Cisco 7200 Series Port Adaptor Hardware Configuration Guidelines" on CCO <www.cisco.com>, for c7200 bandwidth points oversubscription/usage guidelines.
3 FastEthernet/IEEE 802.3 interface(s)
125K bytes of non-volatile configuration memory.
4096K bytes of packet SRAM memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
