I have been experiencing a random router crash on a 7206 router. Link states do not go down, but traffic stops passing and router can not be accessed on any of its Ip interfaces. I have two ways into this router running OSPF. Once the router is rebooted connectivity is restored for about 10-12 hours, then goes dead again. I am getting this PA bandwidth points error when running a show ver. I checked the configuration guide and I am not over the max FE100 interfaces for this router. I also have the interface spreadout across both internal buses. I got an fe100 in port 5, the other in port 6 and the third is on the I/O controller on board. I have attached the sh ver below.
I have other routers with the same exact config and do not receive this error. I am not convinced that this is the reason the router crashed, but need some info.
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-IS-M), Version 12.3(9), RELEASE SOFTWARE (fc2)
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...