Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7206 vxr not booting up

I have an issue with a 7206vxr that is booting into setup mode because it cannot find a configuration.  The config register is set good at 2102 but it boots into setup mode on restart.  I can put a configuration on it and it will run fine from running-config.  the dir nvram: command shows a startup configuration and the dir bootflash:  reveals the ios file fine.  The dir slot0:  reveals nothing however.  It reads device not ready.  This is the case even through it has a pcmcia flash card in the slot.  It seems like it should have enough to boot up between the bootflash and nvram however.  Is there a missing piece here?  Should there be an ios or config on the pcmcia flash?  Either by necessity or good practice? 


7206 vxr not booting up

  Is there a correct boot statement in the config pointing to your image in flash?