I have a 7206VXR NPE400 with two PA-GE (one in slot 1, one in slot 4 so distributed). It also has a 2 port FE IO controller but both ports are shut down and not in use.
What kind of performance should I expect out of the GE ports? I can't find any actual numbers, just a mention of 'moderate performance'. I can't seem to get more than 310-320Mbits/sec on these ports (both running simultaneously) and before I start to try to do a lot of tuning I am wondering what I should expect as far as throughput? It seems to cap out in the 320Mbits/sec range with both input and output drops.
The issue may be due to the congestion on the links or there may be many packes queued at the output interface of the 7206 router. Make sure the collsions are not caused due to any hardware related problems or duplex problems.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...