Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7304 router ethernet interface config problem

I am trying to do a simple config on gigabit ethernet interface of 7304 router. It does not give option for configuring speed,duplex, media. The interface is down/down. I configured IP address and tried everything but it is not coming up. Here is some useful config output. Any thoughts!!

Router#sh ver

Cisco IOS Software, 7300 Software (C7300-IS-M), Version 12.2(28)SB8, RELEASE SOFTWARE (fc1)

cisco 7300 (NSE100) processor (revision E) with 491520K/32768K bytes of memory.

Processor board ID SMQ1141NDD3

R7000 CPU at 350Mhz, Implementation 39, Rev 3.3, 256KB L2, 1024KB L3 Cache

4 slot midplane, Version 69.48

1 FastEthernet interface

2 Gigabit Ethernet interfaces

2 Packet over SONET interfaces

509K bytes of non-volatile configuration memory.

125440K bytes of ATA compact flash in bootdisk (Sector size 512 bytes).

250880K bytes of ATA compact flash in disk0 (Sector size 512 bytes).

Configuration register is 0x2102

Router(config)#int gi0/0


Interface configuration commands:

access-expression Build a bridge boolean access expression

arp Set arp type (arpa, probe, snap) or timeout

backup Modify backup parameters

bandwidth Set bandwidth informational parameter

bgp-policy Apply policy propogated by bgp community string

bridge-group Transparent bridging interface parameters

carrier-delay Specify delay for interface transitions

cdp CDP interface subcommands

channel-group Add this interface to an Etherchannel group

clns CLNS interface subcommands


default Set a command to its defaults

delay Specify interface throughput delay

description Interface specific description

dot1q dot1q interface configuration commands

dspu Down Stream PU

exit Exit from interface configuration mode

fair-queue Enable Fair Queuing on an Interface

glbp Gateway Load Balancing Protocol interface commands

help Description of the interactive help system

hold-queue Set hold queue depth

ip Interface Internet Protocol config commands

ipv6 IPv6 interface subcommands

isis IS-IS commands

keepalive Enable keepalive

lan-name LAN Name command

load-interval Specify interval for load calculation for an interface

locaddr-priority Assign a priority group

logging Configure logging for interface

loopback Configure internal loopback on an interface

mac-address Manually set interface MAC address

max-reserved-bandwidth Maximum Reservable Bandwidth on an Interface

mls mls sub/interface commands

mpoa MPOA interface configuration commands

mtu Set the interface Maximum Transmission Unit (MTU)

negotiation Select autonegotiation mode

netbios Use a defined NETBIOS access list or enable name-caching

no Negate a command or set its defaults

ntp Configure NTP

pppoe pppoe interface subcommands

redirect Redirect rules

sap-priority Assign a priority group

service-policy Configure QoS Service Policy

shutdown Shutdown the selected interface

sna SNA pu configuration

snapshot Configure snapshot support on the interface

snmp Modify SNMP interface parameters

standby HSRP interface configuration commands