Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

802.1x and ATA

hello Team,

I am trying to configure 802.1x on the 2560 switches. We have some ATAs connected. I configured the MAB on the switch and configured the windows IAS server with the ATA MAC as user/password. However; when i connect the ATA to the switch port it doesn't get the IP address. Is there a way to make this work? here's my switch port config.

interface FastEthernet0/29

switchport access vlan 17

switchport mode access

switchport voice vlan 3030

srr-queue bandwidth share 10 10 60 20

srr-queue bandwidth shape 10 0 0 0

priority-queue out

mls qos trust device cisco-phone

mls qos trust cos

auto qos voip cisco-phone

dot1x mac-auth-bypass

dot1x pae authenticator

dot1x port-control auto

dot1x timeout tx-period 10

dot1x timeout supp-timeout 10

dot1x reauthentication

dot1x guest-vlan 999

dot1x auth-fail vlan 999

dot1x auth-fail max-attempts 2

spanning-tree portfast

I appreciate your help.

thanks

Anand

1 REPLY
Silver

Re: 802.1x and ATA

Try to assign static IP address. You can verify which IP address was assigned to the Cisco ATA with the IVR menu.

The Dynamic Host Configuration Protocol (DHCP) server is enabled by default from version 2.x and later. When the DHCP field is set to 1, the Cisco ATA 186 contacts the DHCP server to get the IP address, subnet mask, and default route.

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800c3a50.shtml#task1

685
Views
0
Helpful
1
Replies
CreatePlease to create content