hi everyone, can you help out a newbie? I'm implementing 802.1x auth on my 2950's and all is working fine. However, when I try this out on a 3524 the commands are not supported. The 3524 is running IOS 12.0 (5) Is this an IOS thing? or is the 3500 series not supported?
Unfortunately the 802.1x authentication is not supported on any XL platform. There?s a hardware limitation on this platform to forward the multicast address used for 802.1x. For that reason it won?t work, not even on the latest IOS release.
I don't think there is a comprehensive list with all platforms on which 802.1x authentication is supported. If you have sufficient CCO access, you can use the software advisor (see the link below). 802.x is supported on all the newer switches, starting with the 2950 and upwards. Which ones exactly are you looking for ?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...