Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

802.1x Multi-Host Mode

Hi

I know that in this mode, when the first host authentication fail, the remaining host are limited too. But is it posible that each host can be autheticated

separately without being affected for the firs host, when it fails.

1 REPLY
New Member

Re: 802.1x Multi-Host Mode

The mode you are looking for is multi-auth. Not all switches support - the higher end switches do. I remember it was supported on 3750

build 12.2(50) S.E and later.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_50_se/command/reference/cli1.html

570
Views
0
Helpful
1
Replies
CreatePlease to create content