Hello,
I want test a scenario with different vlans. On my Switch Port is this following configured:
interface GigabitEthernet0/4
switchport mode access
switchport port-security
switchport port-security maximum 5
switchport port-security aging time 2
switchport port-security violation restrict
switchport port-security aging type inactivity
switchport port-security mac-address sticky
speed auto 100
dot1x mac-auth-bypass
dot1x critical recovery action reinitialize
dot1x pae authenticator
dot1x port-control auto
dot1x host-mode multi-host
dot1x control-direction in
dot1x timeout quiet-period 2
dot1x timeout server-timeout 2
dot1x timeout reauth-period server
dot1x timeout tx-period 1
dot1x timeout supp-timeout 2
dot1x max-reauth-req 1
dot1x reauthentication
dot1x guest-vlan 7
dot1x auth-fail vlan 7
dot1x critical vlan 6
spanning-tree portfast
spanning-tree bpduguard enable
My question is, can I combined this features on a port? By corrupted MAC-Address should be the PC in guest-vlan, by corrupted certificate should be the PC in Auth-Fail vlan.
Is that correct?
thanks for your response
Jens