I checked with the Software Advisor on the Cisco web site. You did not specify but I am guessing that you are running the base feature set. This does not include support for OSPF. If you upgrade the software on the router to the PLUS feature set that should include support for OSPF.
if you have cco id with sufficient priviledge access, there is a tool called software advisor, which can give you any IOS, with the feature sets that you want to work with (eg, ipsec, ospf etc).. if u do not have access, pls consult your cisco pre-sales engineer, who will be able to help yu with this. or give us the exact requirement and we will try to find this for u..
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...