Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

871 Initial Configuration

Haven't used router commands in years, so I thought this would be a lot easier in SDM. Rustier than I thought!! Need to create an internal vlan (192.168.1.0) and NAT WAN fe04 with ip that corporate has given us to use (45.245.13.21) to connect to corporate router (45.245.13.20). Need to have internal users on 192.168.0.1 go through 192.168.1.0 vlan connect to corporate 45.245.13.20. Suggestions??  Thanks!!!

Everyone's tags (3)
1 REPLY
VIP Super Bronze

Re: 871 Initial Configuration

Here is the config guide you can start with.  There are examples on how to configure the interfaces with IP, host name , username, password , etc...

http://www.cisco.com/en/US/docs/routers/access/800/850/software/configuration/guide/857sg_bk.pdf

HTH

Reza

1500
Views
0
Helpful
1
Replies