attached to the message is a conf of a 871w router. for some reason wired clients cannot get IPs although wireless clients get them just fine. and if i try to see what is going on with 'debug ip dhcp packets' nothing is showing when connecting wired clients. any thoughts? thanks.
It might sound silly, but are the wired client devices configured to get IP from DHCP?
Also, try enabling spanning-tree portfast on the switchports connected to users. STP convergence can cause problems with DHCP as the PCs mayn't wait long enough for the DHCP response and timeout prematurely.
You need to create a vlan before assigning the port to that vlan. Most newer switches, create a vlan if one doesn't exist when you try to assign a port to a non-existent vlan. Create a vlan 10 as follows and assign the switchport to vlan 10 and see if that helps.
are you sure about 'vlan 10'? because the response is 'Invalid input detected' with the carrot under number 10. the only command that i can see that starts with vlan is 'vlan accounting'. thanks for your response.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.