Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

876 Vlan's

Hello

I have a Cisco 876 router. I have created an extra VLAN, number 2. I have assigned an IP adress and 2 ethernet ports.

For the IP adress of VLAN1 is automaticly an IP route created (C = connected). For VLAN2 this is not?! I also can't create an static route to the IP adress of VLAN2.

What am I doing wrong?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: 876 Vlan's

Hi,

Connect at least one device in Vlan2 access ports and check, it should come up.

Cisco 876 supports upto 2 vlans with base image and upto 4 vlans with advance IP services image. If you have any other vlans, please remove/shutdown them.

Regards,

*aijaz*

5 REPLIES
Bronze

Re: 876 Vlan's

Hi,

Make sure that its not shutdown, do a "no shut" under vlan 2.

rate this if it helps...

Thanks..

*aijaz*

New Member

Re: 876 Vlan's

Hi,

Sorry for the late reaction, but unfortunatly is does not work.

This a part of my config

interface Vlan1

description CustomerLAN

ip address 192.168.10.253 255.255.255.0

ip nat inside

ip virtual-reassembly

ip tcp adjust-mss 1452

!

interface Vlan2

description AtlanticLAN

ip address 192.0.2.254 255.255.255.0

ip nat inside

ip virtual-reassembly

ip tcp adjust-mss 1452

This is my IP route table

Gateway of last resort is not set

C 192.168.10.0/24 is directly connected, Vlan1

10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks

S 10.20.1.0/24 [1/0] via 10.200.0.1

C 10.200.0.0/30 is directly connected, Dialer0

Can you help me further??

Greetz Richard

New Member

Re: 876 Vlan's

Are any of the switchports assigned to vlan 2 up? If you show ip int brief, is VLAN 2 down/down?

Bronze

Re: 876 Vlan's

Hi,

Connect at least one device in Vlan2 access ports and check, it should come up.

Cisco 876 supports upto 2 vlans with base image and upto 4 vlans with advance IP services image. If you have any other vlans, please remove/shutdown them.

Regards,

*aijaz*

New Member

Re: 876 Vlan's

Hi, yes this is the solution!

I only prepared the router. As soon as 1 FastEthernet link was on, the route was added.

It is removed as soon as the link is down.

Thank you for your help

greetz,

Richard

189
Views
0
Helpful
5
Replies