You're using PPPOE with route mode(dialer interface). But you defined ATM as a bride mode. I didn't see any bridge group command on the interfaces. However your internet connections is working fine. Right?.
But coming back to VRRP: Is this Lan or Wan?
To make sure that I'm in the same page. You are going to do VRRP with the LAN interface and trying to use the virtual IP address for hosts in the lan segment. Right? Assuming that the internet connections are working fine. The problem you said is that hosts on lan can't ping the virtual ip address. Right?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...