Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
608
Views
0
Helpful
1
Replies

887VA Configuration

taycommercial
Level 1
Level 1

‎11-28-2013 03:34 AM - edited ‎03-07-2019 04:49 PM

Hi...

I'm trying to configure an 887VA to work with vdsl on BT with multiple IP addresses. I have a configuration for ADSL on an 1841 so was trying to edit the config using CCP version 2.7 and download it back to the router. Every time I try I get "Changing Hostname is not suppoerted. Remove hostname to continue". If I remove the hostname I still get this message.

Has anybody got an answer to this message?

The routing will be done by a Sonicwall behind this router so any ideas on configuration would be appreciated.

2 people had this problem
Labels:
0 Helpful
1 Reply 1

Aaron Coulter
Level 1
Level 1

‎09-05-2014 05:29 AM

I had the same problem too. I've completely abandoned Cisco CCP. It's just too buggy. The only way to configure Cisco routers is command line as far as I'm concerned. 

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card