Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

887va-w solution to have same ip for management and bvi wlan interface ?

Hi, is there a solution to have the same ip on the bvi as the vlan1 ip ?

I want to be able to manage my router thru SSH on the same ip as the embedded AP interface BVi thru http.

Is it possible ?

I don't want to have 2 different ip for management router and access point.

Thanks a lot

Cheers

Jon

Everyone's tags (6)
1 REPLY
Cisco Employee

887va-w solution to have same ip for management and bvi wlan int

The 887 AP IOS runs independently of the router's IOS. They are almost like a separate router and AP connected via an ethernet cable. That why you have to use the service-module wlan-ap 0 session command to reach the console via wlan-ap 0.

If you have a Wireless controller, the AP can actually be controlled/configured via the controller.

You can use the router's IP address for management and then connect to the AP's console from there but since the AP and router are running independent images, there is no easy solution.

457
Views
0
Helpful
1
Replies