Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

a problem about 4503 sup4 bootup

Hi netpro:

I have a sw4503, when power on ,it can't bootup normally and go into rommon mode.

i used the command "dir bootflash:"

rommon 3 >dir bootflash:

Checksum failed on yoda-fslib-m

Expected checksum: 1b4f, calculated checksum: e09d

open: file "yoda-fslib-m" not found

cannot load the monitor library "bootflash:%yoda-fslib-m" from device: Interna

l Flash Memory

dir: cannot open device "bootflash:"

rommon 4 >

I think it maybe a hardware problem,

please help to diagnose it.

Added detail:

when I uesed command "boot tftp://192.168.1.2/c4500-ios.bin",

the ios can transport from pc to sw4503,

but the sw4503 always stick at loaded,no action .

Thank your help.

164
Views
0
Helpful
0
Replies
CreatePlease to create content