Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

A quickie OSPF Question

I want to prevent two Layer 3 Switches from becoming DR/BDR's. I know that I can use the IP Ospf Priority 0 command. But can I use that command within the OSPF process instead of applying it to an interface ?

1 REPLY
Cisco Employee

Re: A quickie OSPF Question

Hi Friend,

DR is a property of an interface and not the entire router so I am afraid this command cannot be configured under ospf process but should be configured on per interfaces.

HTH

Ankur

127
Views
0
Helpful
1
Replies