We are mounting 4 Access points in a parking Lott. We have wired up a cat6 cable to each AP (not power). The cat6 cables are terminated in a weather resistant outdoor box.
My question is: Does Cisco have at rouged switch that can support this setup?
The plan was to use a IE2000. However the IE-2000-16PTC-G-L that we purchased, did not deliver enough power on each port (it can deliver PoE on 4 ports, but only PoE+ on 2) My fault that I did not read the PDF thoroughly enough :-(
So question is, does cisco have a rugged switch that can deliver PoE+ on 4 ports?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...