aborting the show file command ouput in cisco nexus
Hi all ,
In order to verify the md5 value in cisco nexus image we need to use show file bootflash:image md5sum command. But instead of that we given show file bootflash:image . And it is continiously showing the entire file content and full junk values coming in console. I have given ctrl+shift+6 to abort the ouput. But it is not stopping and now i am not able to do anything in console. Any suggestion to abort that.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...