Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Silver

about 6704 module 10Ge

Hi folks,

just a question: with two 6704 4x10Ge modules could I create a 20 Gbit EtherChannel with two links on different modules?

I've tried, but one remains always in err-disable, and I don't understand why.

Any advice will be appreciated

Regards

Andrea

  • LAN Switching and Routing
1 REPLY
Silver

Re: about 6704 module 10Ge

If you switch runs with Cisco IOS software, then use the following document to recover the port from errdisable state.

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00806cd87b.shtml

If you are using Cisco Catalyst OS for your switch, use this document,

http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080093dcb.shtml

244
Views
0
Helpful
1
Replies
This widget could not be displayed.