about 6704 module 10Ge

[ariela]

Hi folks,

just a question: with two 6704 4x10Ge modules could I create a 20 Gbit EtherChannel with two links on different modules?

I've tried, but one remains always in err-disable, and I don't understand why.

Any advice will be appreciated

Regards

Andrea

[b.hsu]

If you switch runs with Cisco IOS software, then use the following document to recover the port from errdisable state.

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00806cd87b.shtml

If you are using Cisco Catalyst OS for your switch, use this document,

http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080093dcb.shtml