Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

about ntp source address

Do you know if is possible to use an ip address (loopback 0) that belong to a VRF as ntp source address?

I have this doubt because the NTP server is reachable by ping and at the moment i'm not able to synch both my 6509 and 3560...thanks a lot

Simone

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: about ntp source address

Yes,

This is very possible as a matter of a fact i use this on my own ISR.

Can you reach the ntp server witch icmp with an extended ping sourced from the loopback interface ?

2 REPLIES
New Member

Re: about ntp source address

Yes,

This is very possible as a matter of a fact i use this on my own ISR.

Can you reach the ntp server witch icmp with an extended ping sourced from the loopback interface ?

New Member

Re: about ntp source address

Yes I can.

I've cheched and in the ntp server command was missing vrf (name of vrf).

thanks again

simone

173
Views
0
Helpful
2
Replies
CreatePlease to create content