About to add more redundant links to an existing topology.
I am about to add 2 addtional links to an existing spanning tree topology so each distribution switch goes directly into the two cores. We have 4 6509s, 2 for the core and 2 for distribution. There are 2 etherchannels from each distribution going straight down to the cores and one etherchannel connecting the the two IDF distribution 6509s together. I will add two etherchannels diagonally to each core. So there would be 2 links from each distribution 6509 to each core 6509. I will then remove the etherchannel between the two distribution 6509s. What could I expect to go wrong with doing this?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...