you mean the switch that is trunking with this port uses vlan1 as native vlan ?Also what is the benefit of port putting itself into that VLAN when trunking is broken since other vlans cannot passthrough anyways ?
you mean the switch that is trunking with this port uses vlan1 as native vlan ?
Yes, you can verify with the commands:
show interface fx/x switchport
show interface trunk
Also what is the benefit of port putting itself into that VLAN when trunking is broken since other vlans cannot passthrough anyways ?
I'm not sure what you mean about benefit. It's your typical Vlan membership configuration. Deciding what port each switchport belongs to in access mode is part of a design - not a benefit. Based on the configuration, Vlan 241 must have a special meaning on the switch and that's the Vlan to use of the port fails its trunk negotiation.
Other Vlans may not pass thru since the trunk is broken but it doesn't mean the interface is down/down state. If the interface is up/up, you can still communicate via Vlan 241.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.