Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access denied

Hi there,

there is two servers one is on VLAN10 and another on VLAN20.

User needs the access between these server on port 80. I tried to telnet on port 80 from to these servers from its respective VLAN which was successfull. But from the server its blocking. I have checked the ACLs there is no such thing to block. the ACL is like this

permit tcp any any reflect tcptraffic.

Can some shen a light on this at the earliest

Thanks in Adv

10 REPLIES
New Member

Re: Access denied

can some one help me please...its very urgent..

If I have missed out any information please let me know

Thanks

Re: Access denied

On which side of the switch is this access-list applied?

Narayan

New Member

Re: Access denied

placed on VLAN10(source) as out

Re: Access denied

Can you try to add the access-list on the other vlan too and check

Narayan

New Member

Re: Access denied

I hope its not required because from Vlan10 to server I can telnet but from server on VLan10 only its not happening...!!!

Why it is happening like this what would be the root cause please...

New Member

Re: Access denied

Is any more suggesstion please.

Did ping and tracert from Server A(VLAN10) to Server B (VLAN20) which was successfull..

Bronze

Re: Access denied

Take out the ACL and what happens?

New Member

Re: Access denied

I hope the secinario is confused for you...

Just to recall..

I can telnet from switch (Vlan interface to server) but not from particular server..

more over the ACL is

permit tcp any any reflect tcptraffic

Bronze

Re: Access denied

Ok then... post switch config and servers ip configuration and mask/gateway information

New Member

Re: Access denied

Can you please guide me the troubleshooting steps..as its policy violation I cant post the config details more over its Distribution layer switch....so masking the sensitive info is bit tough...

please

152
Views
0
Helpful
10
Replies