Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

access-list binding help required

Hello,

This is regarding SNMP config on 2980G Catos switch for ver 8.4.9

We have issued the following commands on the switch:

1)For SNMP Access list : set snmp access-list access_number IP_address [ipmask maskaddr]

I would like to know how binding of access-list are done and where when we defining for SNMP configuration

Regards,

Arindam

2 REPLIES
Silver

Re: access-list binding help required

You can do by using following two commands

router(config)#snmp-server community MyCommunity972 RW 10

router(config)#access-list 10 permit 192.168.1.23

{Note: RW 10 that much be match with access-list No}

Regards,

Dharmesh Purohit

Re: access-list binding help required

There is no binding required. The access-list number mentioned is referenced for all the SNMP inout packets.

Its something similar to using access-list when debugging or for PBR.

HTH

Narayan

121
Views
0
Helpful
2
Replies