Access-list on Dialer Interface

[phlitservices]

Hi All,

How/where do I configure an access-list to secure an ADSL interface that is configured for dynamic IP? Basically I just wanted to add only one or two lines to the ACL e.g.

access-list 102 permit tcp any host (dialer0 interface) established

access-list 102 deny ip any any log

inter dialer0

ip access-gr 102 in

If this can't be done then how does one secure a dialer interface that is configure for dynamic IP?

tks,

Donavan

[i.va]

Hi,

that should work, but it isn't the most secure solution. You might want to check out the Cisco IOS integrated firewall:

http://www.cisco.com/en/US/products/sw/secursw/ps1018/

http://www.cisco.com/en/US/docs/routers/access/500/520/software/configuration/guide/520scg_security.html

(Commands might be different for your device...search for the software configuration guide for your model)

hth