How do i get the (XX) after the ACL in show access-list command. It shows up on routers but not on a 3750. Is this a limitation or a command to turn it on?
Extended IP access list 100
10 permit ip 10.120.1.0 0.0.0.255 10.120.14.0 0.0.1.255
20 deny ip any any
I have 2 networks that are separated. There will be a link between the 2. The only traffic i want to pass will be traffic allowing PCs to authenticate to active directory servers. And exchange the necessary AD stuff down. Any idea what ports to allow for that?
Thanks Jon. You answered the first question. I will try those ports. I was going to do it today but it appears the AD servers are not here. Oh well. Anyone have any other ports that you think should be allowed?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...