Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

access lists

Hi all, when configuring access lists on my router and firewall, woudl i normally use the ip access-list command or just the access-list command ?

3 REPLIES
Purple

Re: access lists

The access list command is the old way of creating the ACL where if you use the ip access list command it puts you into the so called named access list or ACL config mode where you can add and delete entries to the ACL without having to take the whole acl off the interface and reapply it . If you use the ip access list command you will see it will put you into acl config mode .

New Member

Re: access lists

Hi,

Hope you've gone through the following link already.

http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml

I confirm Glen's comments; One of the most interesting features of IP access-lists, I find that reduces the administrative burden is the ability to add and remove rules in between without having to remove and re-enter the entire access-list.

Hall of Fame Super Bronze

Re: access lists

One of the most interesting features of IP access-lists, I find that reduces the administrative burden is the ability to add and remove rules in between without having to remove and re-enter the entire access-list.

That feature is also available with regular ACLs.

See:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc04c4a/2#selected_message

__

Edison.

469
Views
10
Helpful
3
Replies
CreatePlease to create content