Not really sure what your question , when you add the switchport access command all you are doing is saying if the line is not a trunk it will be an access port in vlan 1 . If the port is hardcoded as a trunk the switchport access command really has no meaning and does not need to be there .
The swtchport can be in access mode or in trunking mode.
If it is in access mode, then the command switchport access vlan n determines which VLAN it is on. If that command is absent, then it is on VLAN 1. Any command starting switchport trunk ... is ignored because we are not in trunking mode.
If the switchport is in trunking mode, packets have to be tagged to say which VLAN they are for, except if they are on the native VLAN. The native VLAN is determined by the command switchport trunk native vlan n. If that command is absent, the native is VLAN 1. Any command starting with switchport access ... is ignored because we are not in access mode.
In your output above, te "Access Mode VLAN" is the one the port would be on if it were in access mode. But that is irrelevant, because it is not in access mode; it is in trunk mode.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.